Cruise Control Module: Service and Repair

CRUISE CONTROL MODULE REPLACEMENT

REMOVAL PROCEDURE
The cruise control module is mounted to the left strut tower and must be serviced as a complete unit.




1. Remove the cruise control cable from the cruise control module.
2. Disconnect the cruise control module electrical connector.




3. Remove the cruise control module shock tower nuts.
4. Remove the cruise control module.

INSTALLATION PROCEDURE




1. Install the cruise control module on the mounting studs located on the shock tower.




2. Install the cruise control module mounting nuts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the cruise control module to shock tower nuts to 2 N.m (18 lb in).

3. Connect the cruise control module electrical connector.
4. Install the cruise control cable to the cruise control module.

IMPORTANT: The cruise control cable does not require mechanical adjusting after the replacement. The cruise control module internally adjusts the cable.