Operation CHARM: Car repair manuals for everyone.
Home >> Chevrolet >> 2005 >> Malibu L4-2.2L VIN F >> Repair and Diagnosis >> Relays and Modules >> Relays and Modules - HVAC >> Control Module HVAC >> Service and Repair >> HVAC System - Automatic >> Blower Motor Control Processor Replacement

Blower Motor Control Processor Replacement

BLOWER MOTOR CONTROL PROCESSOR REPLACEMENT

REMOVAL PROCEDURE
1. Remove the right closeout panel.
2. Remove the blower motor control processor wire harness connector.
3. Remove the blower motor control processor screws.




4. Remove the blower motor control processor.

INSTALLATION PROCEDURE




1. Install the blower motor control processor.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Tighten the blower motor control processor screws.

Tighten
Tighten the blower motor resistor screws to 1.5 N.m (13 lb in).

3. Install the blower motor control processor wire harness connector.
4. Install the right closeout panel.
pro multis · About Operation CHARM