Low Washer Fluid Indicator Malfunction

Low Washer Fluid Indicator Malfunction

Diagnostic Fault Information

Important: Always perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview





Circuit/System Description

The low washer fluid indicator is located in the instrument panel cluster (IPC). Ground is applied at all times from G100 through the windshield washer fluid level switch and the low washer fluid indicator signal circuit to the IPC. When the washer fluid is low, the switch opens and ground is removed from the low washer fluid indicator signal circuit to the IPC. The IPC then displays the Low Washer Fluid Level message.

Circuit/System Testing

Low Washer Fluid Indicator Inoperative
1. Ignition OFF, disconnect the harness connector at the windshield washer fluid level switch.
2. Ignition ON, verify that the DIC displays the Washer Fluid Level Low message.

• If the message is not displayed, test the signal circuit for a short to ground. If the circuit tests normal, replace the instrument panel cluster.

3. If all circuits test normal, replace the windshield washer fluid level switch.

Low Washer Fluid Indicator Always On
1. Ignition OFF, disconnect the harness connector at the windshield washer fluid level switch.
2. Ignition OFF, test for less than 1.0 ohm of resistance between the ground circuit terminal B and ground.

• If greater than 1.0 ohm, repair the ground circuit for an open/high resistance.

3. Install a 3-amp fused jumper wire between the signal circuit terminal A and ground.
4. Ignition ON, verify the Washer Fluid Level Low message is not displayed.

• If the Washer Fluid Level Low message is displayed, test the signal circuit for an open high/resistance. If the circuit test normal, replace the IPC.

5. If all circuits test normal, replace the windshield washer fluid level switch.

Repair Instructions

Important: Always perform the Diagnostic Repair Verification after completing the diagnostic procedure.

* Washer Solvent Container Level Sensor Replacement
* Control Module References for IPC replacement, programming and setup. Programming and Relearning Verification Tests