Alarm Module: Service and Repair

Theft Deterrent Module Replacement

Removal Procedure

1. Disconnect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection (Primary) Battery Negative Cable Disconnection and Connection (Primary)Battery Negative Cable Disconnection and Connection (Auxiliary) Battery Negative Cable Disconnection and Connection (Auxiliary).

Warning:
Refer to SIR Warning SIR Warning.


2. Disable the SIR system. Refer to SIR Disabling and Enabling Service and Repair.

3. Remove the steering column trim covers. Refer to Steering Column Trim Cover Replacement Steering Column Trim Cover Replacement.





4. Disconnect the theft deterrent module (TDM) electrical connector (4).

Important:
Rotate the ignition lock cylinder lamp socket counter-clockwise to disengage the locking tangs and pull to detach the ignition lock cylinder lamp socket (2) from the TDM.


5. Detach the ignition lock cylinder lamp socket (2) from the TDM (1).

6. Remove the TDM to steering column assembly retaining screw (3).





7. Remove the TDM (1) from the steering column assembly (2).

Installation Procedure





Important:
Make sure the locating pin on the steering column assembly (2) is aligned with the TDM (1).


1. Install the TDM (1) to the steering column assembly (2).





Caution:
Refer to Fastener Caution Fastener Caution.

2. Install the TDM to steering column assembly retaining screw (3).

Tighten the screw to 1 Nm (9 lb in).

Important:
Rotate the ignition lock cylinder lamp socket counter-clockwise to disengage the locking tangs and pull to detach the ignition lock cylinder lamp socket (2) from the TDM.


3. Detach the ignition lock cylinder lamp socket (2) from the TDM (1).

4. Connect the theft deterrent module (TDM) electrical connector (4).

5. Install the steering column trim covers. Refer to Steering Column Trim Cover Replacement Steering Column Trim Cover Replacement.

6. Connect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection (Primary) Battery Negative Cable Disconnection and Connection (Primary)Battery Negative Cable Disconnection and Connection (Auxiliary) Battery Negative Cable Disconnection and Connection (Auxiliary).

7. Enable the SIR system. Refer to SIR Disabling and Enabling Service and Repair.

8. For programming and set up, refer to Control Module References Control Module References.