Knock Sensor Replacement - Bank 2

Knock Sensor Replacement - Bank 2

Removal Procedure





1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Remove the knock sensor (KS) electrical connector (1) from the KS (2).





3. Remove the KS to engine block retaining bolt (1) from the KS.

4. Remove the KS (2) from the engine.

Installation Procedure





1. Install the KS (2) to the engine.

Caution:
Refer to Fastener Caution Fastener Caution.

2. Install the KS to engine block retaining bolt (1) and tighten to 23 Nm (17 lb ft).





3. Install the KS electrical connector (1) to the KS (2).

4. Lower the vehicle.