C0565

DTC C0565

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors

DTC C0565 47

-
VIN (Vehicle Identification Number) Not Programmed

DTC C0565 71

-
VIN (Vehicle Identification Number) Invalid Serial Data Received

Circuit/System Description

The electronic brake control module (EBCM) receives controller area network (CAN) serial data messages from other modules. The EBCM must be configured with the vehicle identification number (VIN), CAN configuration data and vehicle options. If not properly configured after installation, the EBCM may set a DTC.

The internal fault detection is handled inside the control module. No external circuits are involved.

Conditions for Running the DTC

* Ignition ON.

* Ignition voltage is greater than 10 V.

Conditions for Setting the DTC

C0565 47

VIN is not programmed into the EBCM.

C0565 71

Wrong VIN is programmed into the EBCM.

Action Taken When the DTC Sets

* The EBCM disables the Antilock Brake System (ABS), traction control system and electronic stability control for the duration of the ignition cycle.

* A driver information center message and/or a warning indicator may be displayed.

Conditions for Clearing the DTC

* The condition for setting the DTC is no longer present.

* The history DTC will clear after 100 consecutive fault-free drive cycles have occurred.

Reference Information

Schematic Reference

Antilock Brake System Schematics [1][2]Antilock Brakes / Traction Control Systems

Connector End View Reference

Component Connector End Views Fuel Pump and Level Sensor Assembly

Description and Operation

ABS Description and Operation Description and Operation

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Control Module References for scan tool information

Circuit/System Verification

Verify that DTC C0565 is not set.

If the DTC is set, program the EBCM and verify that the DTC does not rest. If the DTC resets, replace the EBCM.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

Control Module References Control Module References for EBCM replacement, programming and setup