Data Link Connector: Service and Repair

Data Link Resistor Replacement

Removal Procedure





1. Remove the knee bolster. Refer to Knee Bolster Replacement Service and Repair.

2. Remove the front floor console side cover. Refer to Front Floor Console Side Cover Replacement - Right Side (9C3) Front Floor Console Side Cover Replacement - Right Side (9C3)Front Floor Console Side Cover Replacement - Right Side (9C1) Front Floor Console Side Cover Replacement - Right Side (9C1).

3. Remove the instrument panel extension trim panel. Refer to Instrument Panel Lower Extension Side Trim Panel Replacement - Right Side Instrument Panel Lower Extension Side Trim Panel Replacement - Right Side.

4. Remove the tape from the data link resistor (1).

5. Disconnect the data link resistor (1) from the instrument panel harness.

Installation Procedure





1. Connect the data link resistor (1) to the instrument panel harness.

2. Tape the data link resistor (1) to the instrument panel harness.

3. Install the instrument panel extension trim panel. Refer to Instrument Panel Lower Extension Side Trim Panel Replacement - Right Side Instrument Panel Lower Extension Side Trim Panel Replacement - Right Side.

4. Install the front floor console side cover. Refer to Front Floor Console Side Cover Replacement - Right Side (9C3) Front Floor Console Side Cover Replacement - Right Side (9C3)Front Floor Console Side Cover Replacement - Right Side (9C1) Front Floor Console Side Cover Replacement - Right Side (9C1).

5. Install the knee bolster. Refer to Knee Bolster Replacement Service and Repair.