Headlamp Switch: Service and Repair

Headlamp Switch Replacement

Removal Procedure

Warning:
Refer to Battery Disconnect Warning Battery Disconnect Warning.


1. Disconnect the battery ground cable from the battery. Refer to Battery Negative Cable Disconnection and Connection (Primary) Battery Negative Cable Disconnection and Connection (Primary)Battery Negative Cable Disconnection and Connection (Auxiliary) Battery Negative Cable Disconnection and Connection (Auxiliary).





2. Remove the knee bolster. Refer to Knee Bolster Replacement Service and Repair.

3. Release the switch retainers and remove the switch from the knee bolster.

Installation Procedure





1. Connect the headlamp switch electrical connector.

2. Install the headlamp switch (1) to the I/P trim pad.

3. Install the knee bolster. Refer to Knee Bolster Replacement Service and Repair

4. Connect the battery ground cable to the battery. Refer to Battery Negative Cable Disconnection and Connection (Primary) Battery Negative Cable Disconnection and Connection (Primary)Battery Negative Cable Disconnection and Connection (Auxiliary) Battery Negative Cable Disconnection and Connection (Auxiliary).

5. Check all vehicle lights for correct operation.