89. Turbocharger Installation

Turbocharger Installation

Special Tool

EN-49942 - Holding Wrench

For equivalent regional tools, refer to Special Tools Tools and Equipment.

1. Clean the sealing surfaces.

2. Replace the connect fittings on the turbocharger coolant feed pipe and the turbocharger coolant return pipe. Refer to Turbocharger Disassemble 53. Turbocharger Disassemble and Turbocharger Assemble 55. Turbocharger Assemble.





Note:
Mind the turbocharger oil return pipe.

3. Install the turbocharger assembly (1) and a NEW turbocharger gasket (2).





4. Connect the turbocharger oil return pipe to the engine while installing the turbocharger.

5. Install the turbocharger coolant feed pipe hollow screw along with 2 NEW seal rings (1) and (2).





6. Install the 8 NEW turbocharger nuts (1).





Caution:
Refer to Fastener Caution Fastener Caution.

Caution:
Refer to Torque-to-Yield Fastener Caution Torque-to-Yield Fastener Caution.

7. Tighten the 8 turbocharger nuts in a sequence as shown to 8 Nm (71 lb in).

8. Repeat the tightening procedure to ensure a proper fastening of the turbocharger nuts.





9. Connect the turbocharger coolant return hose (6) to the oil cooler coolant inlet pipe and install the turbocharger coolant return pipe bolt (7) to the oil cooler. Tighten the turbocharger coolant return pipe bolt to 8 Nm (71 lb in).

10. Install the turbocharger oil feed pipe (2) along with a NEW rubber seal ring.

11. Install the turbocharger oil feed pipe hollow screw (4) in compound with 2 NEW seal rings (1) and (3).

12. Install the turbocharger oil feed pipe bolt (5) to the oil cooler and tighten to 10 Nm (89 lb in).

13. Tighten the turbocharger oil feed pipe hollow screw to 30 Nm (22 lb ft).





Note:
The EN-49942 - holding wrench (2) should be installed to turbocharger coolant feed pipe as shown. The holding wrench should be installed to avoid twisting of the turbocharger coolant feed pipe during the fastening procedure.

14. Install the EN-49942 - holding wrench (2) to the turbocharger coolant feed pipe. Guide a ratchet wrench (1) along with an extension through EN-49942 - holding wrench to the turbocharger coolant feed pipe hollow screw.





Note:
EN-49942 - holding wrench (2) should be installed to turbocharger coolant feed pipe as shown. The holding wrench should be installed to avoid twist of the turbocharger coolant feed pipe while the fastening procedure.

15. Tighten the turbocharger coolant feed pipe hollow screw with ratchet wrench and extension (1) to 30 Nm (22 lb ft).