C028D

DTC C028D

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provide an overview of each diagnostic category.

DTC Descriptors

DTC C028D 00
- Replace Park Brake Pad Malfunction

Circuit/System Description

The parking brake control module has an internal motor, apply actuator, release actuator, and temperature sensor. The parking brake control module also contains the logic for applying and releasing the park brake when commanded by the park brake control switch. When the parking brake control module receives a signal from the switch, the internal circuit board temperature is checked to verify it is within operating range before the control module performs the requested operation.

Conditions for Running the DTC

Vehicle OFF, Vehicle in Service Mode, Vehicle ON, or Engine Running.

Conditions for Setting the DTC

The parking brake control module has an internal counter which keeps track of dynamic applies. When the counter reaches the threshold value this DTC will set.

Action Taken When the DTC Sets

A message and/or a warning indicator may be displayed.

Conditions for Clearing the DTC

* The parking brake control module clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.

* Adjust or replace the park brake pads.

Reference Information

Schematic Reference

Park Brake System Schematics [1][2]Electrical Diagrams

Connector End View Reference

Component Connector End Views Hybrid/EV Battery Pack X1

Description and Operation

Electronic Parking Brake Control Module Description Description and Operation

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Programming and Relearning for scan tool information

Circuit/System Verification

1. Vehicle in service mode.

2. Verify no additional DTCs are set in other control modules.

• If additional DTCs are set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle Diagnostic Trouble Code (DTC) List - Vehicle

• If no additional DTCs are set

3. Verify that DTC C028D is not set.

• If the DTC is set

1. Verify the park brake cable is connected properly. Refer to Park Brake System Diagnosis Component Tests and General Diagnostics

2. Check park brake pads for excessive wear. Refer to Disc Brake System Diagnosis Disc Brake System Diagnosis

3. Program the K83 parking brake control module. Refer to Electronic Parking Brake Control Module Programming and Setup Testing and Inspection.

4. Vehicle in service mode. Apply and release the park brake.

5. Verify the DTC is not set.

• If the DTC is set,
replace the K83 parking brake control module.

• If the DTC is not set

6. All OK.

• If the DTC is not set

4. All OK.

If DTC is set, replace the rear brake pads and perform the Parking Brake Calibration procedure.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

Control Module References Programming and Relearning for parking brake control module replacement, programming and setup