Second Seat Installation - Vehicle Not Equipped With A Third Seat

Figure D - 2nd Seat Installation - Left Seating Position:

1. Left Seating Position - drill an 8 mm (5/16") diameter hole through the floor pan 50 mm (2") inboard of the left wheelhouse and on the fore and aft center of the flat area of the floor pan located approximately 457 mm (18") rearward of the front edge of the left wheelhouse. Refer to Figure D.

Figure E - 2nd Seat Installation Center or Right Seating Position:

OR

Center Seating Position - drill an 8 mm (5/16") diameter hole through the floor pan 546 mm (21-1/2") rearward of the front edge of the left wheelhouse and on the center of the depressed floor pan rib located 580 mm (22-7/8") inboard of the left wheelhouse. Refer to Figure E.

OR

Right Seating Position - drill an 8 mm (5/16") diameter hole through the floor pan 546 mm (21-1/2") rearward of the front edge of the right wheelhouse on the center of the depressed floor pan rib located 395 mm (15-1/2") inboard of the right wheelhouse. Refer to Figure E.
2. To insure proper sealing of the hole, remove any dirt or foreign material from around the hole on the underside of the floor pan where the sealer is to be applied.

3. Place sealer on the hole from the underside of the floor pan and assemble the bolt, anchor bracket, anchor plate and lock nut to the floor pan as shown. Tighten securely and make certain that the hole is completely sealed.

4. Use the child seat only in the second seat seating position for which the anchor bracket has been installed. Use the child seat as directed in the usage instructions, latching the child seat top strap hook to the anchor bracket as shown.