DTC 31

Wiring Diagram:

CIRCUIT DESCRIPTION
During the "Continuous Monitoring" tests the DERM monitors the voltage at "Driver Source Sense" terminal "A5." When the circuit is operating normally the measured voltage will be slightly less than "Driver 36 VLR." If the "Driver 36 VLR" circuit opens, the voltage measured at "Driver Source Sense" will decrease to slightly less than "Ignition 1" voltage. When the voltage measured at "Driver Source Sense" is within a specified range of "Ignition 1," for 500 milliseconds, DTC 31 is set.

DTC WILL SET WHEN
The voltage measured at "Driver Source Sense" terminal "A5" is within a specified range of "Ignition 1," for 500 milliseconds during "Continuous Monitoring."

ACTION TAKEN
DERM turns "ON" the "AIR BAG" warning lamp and sets a diagnostic trouble code.

DTC WILL CLEAR WHEN
The voltage measured at "Driver Source Sense" terminal "A5" is outside the specified range of "Ignition 1" which sets the diagnostic trouble code, for 500 milliseconds.

DTC TABLE TEST DESCRIPTION
Number(s) below refer to step number(s) on the diagnostic table.
1. The "SIR DIAGNOSTIC SYSTEM CHECK" must be the starting point for all diagnostics.
12. This test checks for an open in the "Driver 36 VLR" circuit between the DERM and the arming sensor connector.
15. This test checks for an open in the "Driver 36 VLR" circuit between the arming sensor jumper harness connector and the DERM.
18. This test checks for high resistance in the "Driver Source Sense" circuit between the DERM and the arming sensor connector.
21. This test checks for high resistance in the "Driver Source Sense" circuit between the DERM and the arming sensor jumper harness electrical connector (C106).
24. This test checks for a short from the "Driver Source Sense" circuit to B+.

DIAGNOSTIC AIDS
An intermittent condition is likely to be caused by a poor connection at arming sensor or arming sensor jumper harness electrical connector (C106) terminal "B" or "C," poor connection at DERM terminal "A4" or "A5," an open in CKT 236 or CKT 1400 to B+, or a high resistance inside the arming sensor.