Changing the Feature Customization Modes

Perform the following procedure to change the feature customization modes:
1. Turn off the I/P dimmer switch.
2. Turn the ignition switch to the LOCK position.
3. Remove the BCM PRGRM Fuse.
4. Turn the ignition switch to the ACC position.
^ The BCM flashes the fasten belts indicator and flashes the fasten belts indicator and sounds the chime four times, identifying that the BCM type 4 is installed on the vehicle.
^ Now the BCM has entered the feature customization mode.
5. To change the theft deterrent/shock sensor mode, turn the headlamp switch from OFF to PARK, back to OFF.
^ The BCM flashes the fasten belts indicator and sounds the chime a number of times equivalent to the theft deterrent/shock sensor mode. A transition past mode 4 repeats the sequence starting with mode 1.
6. To change the theft deterrent arm/disarm modes mode, insert key in the LF, RF or liftgate door lock cylinder; rotate key from the center to unlock position (hold key in the unlock position for 1 second), and then back to the center position.
^ The BCM flashes the fasten belts indicator and sounds the chime a number of times equivalent to the theft deterrent arm/disarm mode. A transition past mode 3 repeats the sequence starting with mode 1.

To exit and save the current feature customization modes:
1. Turn the ignition switch to the LOCK position.
2. Reinstall the BCM PRGRM Fuse.

If unable to change locking modes, refer to Table: Cannot Change Feature Customization Modes for diagnosis and repair. Table1: Cannot Change Feature Customization Modes