Instrument Panel Cluster Replacement

REMOVAL PROCEDURE




1. Remove the IP cluster trim plate.
2. Remove the screws from the IP cluster to instrument panel.
3. Remove the IP cluster from the instrument panel.




4. Disconnect the electrical connectors.

INSTALLATION PROCEDURE




1. Connect the electrical connectors.




2. Position the IP cluster to the instrument panel.

NOTICE: Refer to Fastener Notice in Cautions and Notices.

3. Install the screws that retain the IP cluster to the instrument panel.

Tighten
Tighten the screws to 2.5 N.m (22 lb in).

Ensure that the screws are tightened in the following sequence:
3.1. Lower left screw
3.2. Lower right screw
3.3. Upper left screw
3.4. Upper right screw
4. Install the instrument cluster trim plate.