Oil Filter: Service and Repair

Removal Procedure

Important: When performing an oil filter and oil change on a 6.5L diesel engine, use only 8 quarts of oil. This will bring the oil level between ADD and FULL, which is normal. Start the vehicle and wait until the engine reaches normal operating temperature. Shut the vehicle off and wait a minimum of 15 minutes before checking the oil level. It should read Full or very close to Full. Do not check the oil level when the engine is cold, a false reading will occur.

1. Raise the vehicle and support with safety stands. Refer to lifting.





2. Remove the oil filter from the engine block.
3. Remove the drain plug from the oil pan.

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the oil filter to the engine block.
^ Tighten the oil filter to 40 Nm (30 ft. lbs.).
2. Install the drain plug to the oil pan.
^ Tighten the drain plug to 40 Nm (30 ft. lbs.).
3. Remove the safety stands and lower the vehicle.
4. Fill the crankcase with engine oil.