C0362

Circuit Description
CKT 1694 is used to notify the vehicle control module (VCM) powertrain control module (PCM) that the vehicle is in 4WD low range. The vehicle control module (VCM) powertrain control module (PCM) supplies 12 V on this circuit. The transfer case shift control module supplies a ground on this circuit when the vehicle is in 4WD low range.
This DTC detects an transfer case shift control module problem, a short to voltage on CKT 1694.
Conditions for Setting the DTC
^ After the system turns the output on, (grounding CKT 1694), and reads back a high voltage, the DTC is set. The system will not attempt it again during that ignition cycle.
^ The transfer case shift control module reads back a high voltage when a low voltage is expected on the 4WD discrete output, CKT 1694.
Action Taken When the DTC Sets
^ May affect the transmission shift points.
^ The SERVICE indicator (AWD/4WD) lamp will be latched on for the remainder of the current ignition cycle.
Conditions for Clearing the DTC
^ The transfer case shift control module will clear the DTC it the condition for setting the DTC no longer exits.
^ A history DTC will clear after 100 consecutive ignition cycles without a fault present.
^ History DTCs can be cleared using a scan tool.
Test Description
The number(s) refer to the step number(s) on the diagnostic table.
2. This step determines if the transfer case shift control module is receiving the specified voltage from the vehicle control module (VCM)/powertrain control module (PCM).
4. This step determines if CKT 1694 has a short to voltage.