Feature Customization - Changing Modes
Changing the Feature Customization Modes1. Turn off the IP dimmer switch.
2. Turn the ignition switch to the LOCK position.
3. Remove the BCM PRGRM fuse.
4. Turn the ignition switch to the ACC position. The BCM flashes the fasten belts indicator and sounds the chime 4 times, which indicates that BCM type 4 is installed on the vehicle. At this point, the BCM has entered the feature customization mode.
5. In order to change the theft deterrent/shock sensor mode, turn the headlamp switch from OFF to PARK and back to OFF.
The BCM flashes the fasten belts indicator and sounds the chime a number of times equivalent to the theft deterrent/shock sensor mode. A transition past mode 4 repeats the sequence starting with mode 1.
6. Complete the following steps in order to change the theft deterrent arm/disarm mode:
6.1. Insert the key in the left front, right front, or Liftgate door lock cylinder.
6.2. Rotate the key from the center to the unlock position.
6.3. Press the horn button on the remote keyless entry transmitter.
6.4. Count the number of chimes that you hear. The number of chimes tells you which mode you have set.
6.5. Press the horn button again in order to change the mode. Continue to press the button until you hear the number of chimes that indicates the mode that you want.
6.6. Turn the key back to the center position and remove the key from the door key cylinder.
In order to exit and save the current feature customization modes use the following procedure:
1. Turn the ignition switch to the LOCK position.
2. Reinstall the BCM PRGRM fuse.
If you are unable to change locking modes Theft Deterrent System Feature Customization Inoperative