Turn Signal Operation

The turn/hazard relay and the combination (light/turn signal) switch control the turn signal operation.

The turn/hazard relay is located on the back of the junction block. The junction block is located beneath the left side of the instrument panel and is mounted to the left front side door hinge pillar.




The light/turn signal switch lever is on the left side of the steering column. Turn the ignition switch to the ON position in order to allow the turn signals to operate.

When making a partial turn, such as when changing lanes, the driver has the option of moving the lever to a detent stop. The turn signal indicator continues to flash while the lever occupies this position. The flashing will cancel automatically when the lever is released. The detent position allows the driver to make a lane change or a shallow turn without failing to cancel the [1][2]turn signal lamp. Move the lever past the detent position to either the upward or downward position in order provide conventional turn signal operation.

The combination switch and levers are replaced only as a assembly. For combination switch removal and installation procedures, refer to Inflatable Restraint Steering Wheel Module Coil Replacement in Restraint Systems.