Instrument Panel (IP) - Carrier Replacement - Installation - Procedure B

IMPORTANT: If you only used Removal Procedure A, skip Installation Procedure B and proceed directly to Installation Procedure A.

1. Install the IP storage compartment door striker.
2. Install the IP storage compartment door check strap to the tubular steel tie bar.
3. Install both of the air outlet deflectors.
4. Connect the parking brake release handle.
5. Install the side window defogger outlets.
6. Install the courtesy lamp switch.
Connect the electrical connector.
7. Install the jumper harness to the remote playback device (if equipped).
8. Install the harness to the IP.
9. Install the ground screw.
10. Install the fuse panel and the courtesy lamp switch.
11. Install the harness retainer to accessory switches.
12. Install the data link connector (DLC).
12.1. Slide in the DLC.
12.2. Install the one screw.
13. Install the low coolant module (Diesel only).
14. Install the IP storage compartment lamp.
15. Install the rosebud retainers for the harness on the right side of the IP.




16. Install the retaining clips to the IP compartment assembly.
17. Connect the antenna lead-in.
18. Install the air distributor duct to the IP.

NOTE: Refer to Fastener Notice in Service Precautions.

19. Install the 2 air distributor duct screws.

Tighten
Tighten the 2 air distributor duct screws to 2 N.m (18 lb in).

20. Install the radio into the carrier.
21. Install the ashtray assembly.
22. Install the IP cupholder.




23. Install the IP auxiliary storage compartment (if equipped).
24. Install the instrument cluster.
25. Install the HVAC control assembly.
26. Install the headlamp switch.
27. Install the instrument cluster bezel.




28. Install the accessory switch(es) as necessary.