Knock Sensor 2 Replacement

Knock Sensor 2 Replacement

Removal Procedure

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Remove the wiring harness connector from the knock sensor (2).

Diagram:

3. Remove the knock sensor (2) from the engine block (1).

Installation Procedure

Diagram:

Notice: Refer to Fastener Notice .

1. Install the knock sensor (2) into the engine block (1).

Tighten the knock sensor to 19 Nm (14 lb ft).

2. Connect the harness connector to the knock sensor (2).