P1171

SYSTEM DESCRIPTION
The Powertrain Control Module (PCM) internal circuity can identify if the vehicle fuel system is capable of supplying adequate amounts of fuel during heavy acceleration (Power Enrichment). When a power enrichment mode of operation is requested during a Closed Loop operation (by heavy acceleration), the PCM provides additional fuel to the engine. Under these conditions the PCM should detect a rich condition. Whenever this rich exhaust is not detected, a Diagnostic Trouble Code (DTC) P1171 sets. A plugged fuel filter or restricted fuel line can prevent adequate amounts of fuel from being supplied during Power Enrichment Mode.

CONDITIONS FOR RUNNING THE DTC
^ DTCs P0131, P0132, P0133, P0134, or P1133 are not set.
^ The Engine Coolant Temperature (ECT) is more than 20°C (70°F).
^ The engine has been running for longer than 20 seconds.
^ The engine is operating in a Closed Loop operation.

CONDITIONS FOR SETTING THE DTC
^ The O2S 1 voltage is less than 300 mV for 5 seconds.
^ The engine is in the power enrichment mode.

ACTION TAKEN WHEN THE DTC SETS
^ The control module stores the DTC information into memory when the diagnostic runs and fails.
^ The Malfunction Indicator Lamp (MIL) will not illuminate.
^ The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Failure Records.
^ The driver information center, if equipped, may display a message.

CONDITIONS FOR CLEARING THE DTC
^ A current DTC Last Test Failed clears when the diagnostic runs and passes.
^ A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic.
^ Use a scan tool in order to clear the DTC.

DIAGNOSTIC AIDS
^ A restricted fuel filter can supply adequate amounts of fuel at idle, but may not be able to supply enough fuel during heavy acceleration. Water or alcohol in the fuel may cause low O2S 1 voltage during acceleration.
^ Check for faulty or plugged fuel injectors.

TEST DESCRIPTION

Steps 1-7:

The number below refers to the step number on the diagnostic table.
5. This step checks to see if the O2S 1 is operating properly.