Knock Sensor (KS) 1 Replacement

Knock Sensor (KS) 1 Replacement

Removal Procedure

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair in General Information.
2. Remove the wiring harness connector (1) from the knock sensor (2).




3. Remove the knock sensor (2) from the engine block.

Installation Procedure





Notice: Refer to Fastener Notice in Cautions and Notices.

1. Install the knock sensor (2) into the engine block.

Tighten the knock sensor to 19 Nm (14 lb ft).

2. Connect the knock sensor harness connector (1) to the knock sensor (2).