Lock Housing Assembly - Assemble - Off Vehicle

Lock Housing Assembly - Assemble - Off Vehicle




1. Lubricate the switch actuator pivot pin (2).
2. Install the switch actuator pivot pin (2) to the windshield wiper and washer switch assembly (1).





Important: For standard columns, proceed to step 13.


3. Align the lock housing cover assembly (1) onto the steering column.
4. Lubricate the dimmer switch rod actuator (3) with lithium grease.
5. Install the dimmer switch rod actuator (3) into the lock housing cover assembly (1).
6. Align the dimmer switch rod actuator (3) with the dimmer switch actuator rod.
7. Install the column housing cover end cap (2) to the lock housing cover assembly (1).





Notice: Refer to Fastener Notice in Cautions and Notices.

8. Secure the lock housing cover assembly using 3 pan head 6 lobe soc tap screws (1).

Tighten the 3 pan head 6 lobe soc tap screws to 9 Nm (80 lb in).




9. Lubricate the inner race (2) with lithium grease.
10. Install the inner race (2) to the steering shaft assembly.
11. Install the upper bearing inner race seat (1) to the steering shaft assembly.
12. Install the steering column lock cylinder set. Refer to Steering Column Lock Cylinder Set - Assemble - Off Vehicle Steering Column Lock Cylinder Set - Assemble - Off Vehicle.




13. For standard columns, align the steering column housing assembly (1) onto the steering column.
14. Align the dimmer switch actuator rod to the steering column housing assembly.
15. Align the ignition switch actuator assembly to the steering column housing assembly.
16. Install the steering column housing assembly and secure using 4 hex washer head tapping screws (3).

Tighten the 4 hex washer head tapping screws (3) to 5.5 Nm (48 lb in).

17. Install the thrust washer (2) onto the steering shaft assembly.
18. Install the steering column lock cylinder set. Refer to Steering Column Lock Cylinder Set - Assemble - Off Vehicle Steering Column Lock Cylinder Set - Assemble - Off Vehicle.