Multifunction Alarm Module Replacement

REMOVAL PROCEDURE
The multifunction alarm (1) is located in the upper right comer of the rear of the instrument cluster (2).

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.




1. Disconnect the negative battery cable.
2. Remove the instrument cluster. Refer to Instrument Panel Cluster (IPC) Replacement.
3. Remove the following from the rear of the instrument cluster (2):
3.1. The multifunction alarm retainer
3.2. The multifunction alarm (1)

INSTALLATION PROCEDURE




1. Install the multifunction alarm (1) to the rear of the instrument cluster (2). Secure the alarm with the retainer.
2. Install the instrument duster. Refer to Instrument Panel Cluster (IPC) Replacement.
3. Connect the negative battery cable.