C0367

DTC C0367

Circuit Description
The front axle control circuit consists of a front drive axle clutch solenoid, which is electronically controlled by the transfer case shift control module. This solenoid opens and closes a vacuum control valve, allowing vacuum to apply and release a clutch pack inside the front axle housing. The transfer case shift control module determines if the clutch pack has been applied or released. This determination is based on a signal from the front axle switch, which is mounted on the front axle housing assembly. The front axle is normally locked, or engaged during AUTO 4WD, 4WD HI, and 4WD LO modes. The front axle is unlocked or disengaged only during 2 HI or Neutral modes.

DTC Descriptor
This diagnostic procedure supports this DTC:
DTC C0367 Front Axle Control Circuit High

Conditions for Running the DTC
^ The ignition is ON.
^ The system voltage is 9-16 volts.

Conditions for Setting the DTC
^ The system tries to engage the front axle. If the front axle cannot engage, the system will not attempt to engage the front axle again during that ignition cycle.
^ The transfer case shift control module reads back the front axle output as a high voltage when a low voltage is expected.

Action Taken When the DTC Sets
^ SERVICE 4WD indicator remains illuminated for the remainder of the current ignition cycle.
^ All shifting for 4WD, AUTO 4WD, and 4WD LO modes is disabled.

Conditions for Clearing the DTC
^ The transfer case shift control module clears the DTC if the condition for setting the DTC does not exist.
^ A history DTC clears after 100 consecutive ignition cycles without a fault present.
^ History DTCs can be cleared using a scan tool.

Steps 1-7:

Test Description
These numbers correspond to the step numbers on the diagnostic table.
2. This step tests the operation of the front axle switch.
3. This step tests the front axle control circuit for a short to voltage.
4. This step helps determine whether the short to voltage is due to a faulty transfer case shift control module or wiring.