B2365

DTC B2365

CIRCUIT DESCRIPTION
The driver seat adjuster motors are equipped with potentiometer type position sensors used by the driver seat module (DSM) to determine the seat position. The position sensors are supplied with 5-volt reference and ground circuits from the driver seat module. The position sensor signal circuits are referenced from ground within the driver seat module. The signal circuit voltage levels monitored by the driver seat module range from 0.39-4.58 volts and are determined by the wiper locations on the resistors within the motor position sensors. The position sensor circuit voltage levels are used by the driver seat module to determine the seat position when storing or recalling memory position settings.

DTC DESCRIPTORs
This diagnostic procedure supports the following DTCs:
- DTC B2355 Driver Seat Front Vertical Position Sensor Circuit
- DTC B2365 Driver Seat Rear Vertical Position Sensor Circuit
- DTC B2375 Driver Seat Horizontal Position Sensor Circuit

CONDITIONS FOR RUNNING THE DTC
Battery voltage to the seat module must be within 8-17 volts.

CONDITIONS FOR SETTING THE DTC
The position sensor signal circuit voltage level to the driver seat module is not within the 0.39-4.58 volt range.

ACTION TAKEN WHEN THE DTC SETS
The memory recall functions for the seat motor with a current status DTC will be disabled.

CONDITIONS FOR CLEARING THE DTC
- The DTC will be stored as a history code when the fault is no longer present.
- A history DTC will be cleared after completing 100 consecutive ignition cycles, or by using the scan tool clearing DTCs feature.

DIAGNOSTIC AIDS
If the DTC is only found in history, the fault may be intermittent.

TEST

Steps 1 - 10:

Steps 11 - 15: