Energy Storage Box (ESB) Service Disconnect Power Cable Replacement

ENERGY STORAGE BOX (ESB) SERVICE DISCONNECT POWER CABLE REPLACEMENT

REMOVAL PROCEDURE




1. Remove the energy storage box (ESB) intermediate cover.
2. Remove the service disconnect power cable nuts (1) from the high current connector (HCC) and the service disconnect switch.
3. Remove the service disconnect power cable (2) from the HCC and service disconnect switch.

INSTALLATION PROCEDURE




1. Install the service disconnect power cable (2) to the HCC and service disconnect switch.

IMPORTANT: Ensure that the power cable is installed to the negative side of the HCC.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the service disconnect power cable nuts (1) to the HCC and the service disconnect switch.

Tighten the nuts to 10 N.m (89 lb in).

3. Install the ESB intermediate cover.