P2610

DTC P2610

DESCRIPTION
This diagnostic applies to internal microprocessor integrity conditions within the engine control module (ECM). This diagnostic also addresses if the ECM is not programmed.

DTC DESCRIPTORS
This diagnostic procedure supports the following DTCs:
- DTC P0601 Control Module Read Only Memory (ROM)
- DTC P0602 Control Module Not Programmed
- DTC P0603 Control Module Long Term Memory Reset
- DTC P0604 Control Module Random Access Memory (RAM)
- DTC P1621 Control Long Term Memory Performance
- DTC P2610 Control Module Ignition Off Timer Performance

CONDITIONS FOR RUNNING THE DTC
- DTC P0601, P0603, P0604, and P1621 run during power up.
- DTC P0602 and P2610 run continuously.

CONDITIONS FOR SETTING THE DTC
These codes will set when there is incomplete programming or an internal failure within the ECM within 15 seconds.

ACTION TAKEN WHEN THE DTC SETS

DTC P0601, P0602, and P0604
- The control module illuminates the malfunction indicator lamp (MIL) when the diagnostic runs and fails.
- The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Freeze Frame/Failure Records.

DTC P0603 and P1621
- The control module stores the DTC information into memory when the diagnostic runs and fails.
- The MIL will not illuminate.
- The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Failure Records.
- The driver information center (DIC), if equipped, may display a message.

DTC P2610
- The control module illuminates the MIL on the second consecutive ignition cycle that the diagnostic runs and fails.
- The control module records the operating conditions at the time the diagnostic fails. The first time the diagnostic fails, the control module stores this information in the Failure Records. If the diagnostic reports a failure on the second consecutive ignition cycle, the control module records the operating conditions at the time of the failure. The control module writes the operating conditions to the Freeze Frame and updates the Failure Records.

CONDITIONS FOR CLEARING THE MIL/DTC

DTC P0601, P0602, P0604, and P2610
- The control module turns OFF the MIL after 3 consecutive ignition cycles that the diagnostic runs and does not fail.
- A current DTC, Last Test Failed, clears when the diagnostic runs and passes.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
- Clear the MIL and the DTC with a scan tool.

DTC P0603 and P1621
- A current DTC, Last Test Failed, clears when the diagnostic runs and passes.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic.
- Clear the DTC with a scan tool.

TEST DESCRIPTION

Steps 1-7:

The number below refers to the step number on the diagnostic table.
2. A DTC P0602 indicates the ECM is not programmed.