P1660
DTC P1660
CIRCUIT DESCRIPTION
The serial interface driver module (SIDM) is a control chip inside of the powertrain control module (PCM). The driver module provides grounded output control of devices. The driver module output has an internal feedback circuit that connects to the PCM microprocessor. The PCM monitors voltage through the ignition 1 voltage circuit. Excessive voltage or current may cause damage to the PCM. If the driver module detects excessive current or voltage on an output control circuit, this DTC will set.
DTC DESCRIPTOR
This diagnostic procedure supports the following DTC:
DTC P1660 Control Module Output C Circuit
CONDITIONS FOR RUNNING THE DTC
The ignition is ON.
CONDITIONS FOR SETTING THE DTC
- The SIDM has detected a voltage greater than 26.5 volts.OR
- Excessive current is detected on any circuit to the SIDM.
- The above conditions are present for 30 seconds.
ACTION TAKEN WHEN THE DTC SETS
- The control module stores the DTC information into memory when the diagnostic runs and fails.
- The malfunction indicator lamp (MIL) will not illuminate.
- The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Failure Records.
- The driver information center, if equipped, may display a message.
CONDITIONS FOR CLEARING THE DTC
- A current DTC Last Test Failed clears when the diagnostic runs and passes.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic.
- Clear the DTC with a scan tool.
DIAGNOSTIC AIDS
- A condition with the charging system may cause this DTC to set. Refer to Charging System Test in Starting and Charging. Component Tests and General Diagnostics
- For an intermittent condition, refer to Testing for Intermittent Conditions and Poor Connections in Diagnostic Aids.
TEST
