Energy Storage Box (ESB) Sensor Carrier Replacement

ENERGY STORAGE BOX (ESB) SENSOR CARRIER REPLACEMENT

CAUTION:
- To reduce the risk of severe shock and burns, disable the 42 volt (42V) system anytime you perform service work on or around the energy storage box (ESB). The 42V system will still be active after you have disabled the ESB.
- To reduce the risk of severe shock and burns, always disconnect the 42 volt (42V) energy storage box (ESB) before doing any work to the ESB system. To disconnect the ESB, turn the engine off and turn OFF the service disconnect switch, which is located on the passenger side of the ESB.

REMOVAL PROCEDURE




1. Remove the high current sensor.
2. Remove the high current sensor carrier nut.
3. Remove the high current sensor carrier.

INSTALLATION PROCEDURE




1. Install the high current sensor carrier.
2. Install the high current sensor carrier nut.

Tighten the nut to 10 N.m (89 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the high current sensor.