P1021

DTC P1021

CIRCUIT DESCRIPTION
The powertrain control module (PCM) controls fuel delivery and determines fuel system operation on Bi-fuel (KL6) vehicles. The PCM is not capable of operating the high current compressed natural gas (CNG) fuel injectors. The PCM injector pulse width modulated (PWM) signals are received by the fuel injector control module (FICM) and duplicate PWM signal are generated by the FICM in order to operate the CNG injectors. Ignition voltage is supplied to the fuel injectors. The FICM controls each CNG fuel injector by grounding the control circuit via a solid state device called a driver. The FICM monitors the status of each driver. If the control module detects an incorrect voltage for the commanded state of the driver, a fuel injector control DTC P1021-P1028 sets.

DTC DESCRIPTORS
This diagnostic procedure supports the following DTCs:
- DTC P1021 Auxiliary Injector 1 Control Circuit
- DTC P1022 Auxiliary Injector 2 Control Circuit
- DTC P1023 Auxiliary Injector 3 Control Circuit
- DTC P1024 Auxiliary Injector 4 Control Circuit
- DTC P1025 Auxiliary Injector 5 Control Circuit
- DTC P1026 Auxiliary Injector 6 Control Circuit
- DTC P1027 Auxiliary Injector 7 Control Circuit
- DTC P1028 Auxiliary Injector 8 Control Circuit

CONDITIONS FOR RUNNING THE DTC
- The ignition voltage is between 6-18 volts.
- The engine is operating on CNG.

CONDITIONS FOR SETTING THE DTC
- The FICM detects an incorrect voltage on a CNG fuel injector control circuit.
- The condition exists for 5 seconds.

ACTION TAKEN WHEN THE DTC SETS
- The control module illuminates the malfunction indicator lamp (MIL) when the diagnostic runs and fails.
- The control module switches over to gasoline fuel operation.
- The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Freeze Frame/Failure Records.

CONDITIONS FOR CLEARING THE MIL/DTC
- The control module turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail.
- A current DTC, Last Test Failed, clears when the diagnostic runs and passes.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
- Clear the MIL and the DTC with a scan tool.

DIAGNOSTIC AIDS
- Performing the Fuel Injector Coil Test may help to isolate an intermittent condition. Refer to Fuel Injector Coil Test. Fuel Injector Coil Test
- For an intermittent condition, refer to Intermittent Conditions. Intermittent Conditions

TEST DESCRIPTION

Step 1 - Step 11:

Step 12 - Step 14:

The numbers below refer to the step numbers on the diagnostic table.
2. The engine must Crank or Run on CNG in order for this DTC to test.
4. This step verifies that the FICM is able to control the fuel injector.Bi-fuel (KL6) equipped vehicles must be operating on alternative fuel prior to pulsing the CNG fuel injector.
5. This step tests if a ground is constantly being applied to the fuel injector.
10. A short to ground of the CNG injector B+ circuit will open the inline fuse and cause an entire cylinder bank to set DTCs. Test the CNG injector B+ circuits, bank injector monitor circuit, and the FICM for a shorted condition whenever the inline fuse has opened.