Seat Replacement - Rear No. 1 (Trailblazer EXT, Envoy XL)

SEAT REPLACEMENT - REAR NO. 1

REMOVAL PROCEDURE
1. Remove the communication interface module if removing the right-hand rear seat.




2. Remove the front 2 rear seat mounting nuts (2) securing the seat to the vehicle.
3. Fold the seat to the stowed position.
4. Remove the rear 2 rear seat mounting nuts (2) securing the seat to the vehicle.
5. Remove the seat from the vehicle.

INSTALLATION PROCEDURE




1. Position the seat onto the floor studs. The seat should be in the folded position.
2. Install the 2 rear nuts (2). Do not tighten the nuts.
3. Unfold the seat to ensure that the seat latch (1) properly engages the latch bar (3) on the floor.
4. Install the front 2 rear seat mounting nuts (2).

NOTE: Refer to Fastener Notice .

Tighten the front rear seat mounting nuts to 45 N.m (33 lb ft).

5. Fold the seat to the stowed position.
6. Tighten the 2 rear seat mounting nuts (2).

Tighten the rear seat mounting nuts to 45 N.m (33 lb ft).

7. Install the communication interface module if installing the right-hand rear seat.