Windshield Washer Reservoir: Service and Repair

WASHER SOLVENT CONTAINER REPLACEMENT

REMOVAL PROCEDURE




1. Open and support the hood.
2. Remove the upper fender support bar.
3. Remove the bolt from the washer solvent container.




4. Lift the washer solvent container up enough pass the horns in order to access the washer hose and the electrical connector.
5. Disconnect the electrical connector from the washer pump.
6. Disconnect the washer hose from the washer pump.
7. Remove the washer solvent container from the vehicle.
8. Drain the washer solvent reservoir into a suitable container.




9. Remove the washer pump from the washer solvent container.
10. Remove the washer solvent container cap.

INSTALLATION PROCEDURE




1. Install the washer pump to the new washer solvent container.
2. Install the washer solvent container cap.




3. Connect the electrical connector to the washer pump.
4. Remove the cap on the washer pump and connect the washer hose to the washer pump.
5. Position the washer solvent container into the locating holes in the chassis.

6. NOTE: Refer to Fastener Notice.




Install the washer solvent container with the bolt.

Tighten the bolt to 10 N.m (89 lb in).

7. Install the upper fender support bar.
8. Fill the washer solvent container.
9. Close the hood.