Intake Air Temperature (IAT) Sensor 2 Replacement

Intake Air Temperature (IAT) Sensor 2 Replacement

Removal Procedure




1. Remove the air intake pipe.
2. Disconnect the engine wiring harness electrical connector (1) from the intake air temperature (IAT) sensor pigtail.
3. Remove the IAT sensor (2) from the center intake manifold.

Installation Procedure






Notice: Refer to Fastener Notice.

1. Install the IAT sensor (2) to the center intake manifold.

Tighten the sensor to 25 N.m (18 lb ft).

2. Connect the engine wiring harness electrical connector (1) to the IAT sensor pigtail.
3. Install the air intake pipe.