Chime Always On

CHIME ALWAYS ON

DIAGNOSTIC FAULT INFORMATION
Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview

CIRCUIT/SYSTEM DESCRIPTION
The radio generates the audible warning through the left front speaker. The radio receives audible warning requests via GMLAN serial data from the body control module (BCM).

CIRCUIT/SYSTEM TESTING
1. Ignition ON, headlamp switch OFF, verify the scan tool Headlamp Switch parameter is Inactive.
- If not Inactive, test the headlamps signal circuit for an open or short to voltage. If the circuit tests normal, replace the headlamp switch.
2. Ignition ON, park lamp switch OFF, verify the scan tool Park Lamp Switch parameter is Inactive.
- If not Inactive, test the park lamp switch signal circuit for an open or short to voltage. If the circuit tests normal, replace the headlamp switch.
3. Ignition OFF, key out of the ignition, verify the scan tool Key In Ignition Status parameter is Key Out.
- If not Key Out, test the key in ignition switch signal circuit for an open or short to voltage. If the circuit tests normal, replace the ignition switch.
4. Ignition ON, doors closed, verify the scan tool Door Ajar Switch parameters are Inactive.
- If not Inactive, go to Courtesy Lamps Always On.
5. If all circuits test normal, replace the BCM.

REPAIR INSTRUCTIONS
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
- Ignition and Start Switch Replacement
- Turn Signal Multifunction Switch Replacement
- Control Module References for BCM replacement, setup, and programming. Programming and Relearning Verification Tests