Odometer Trip/Reset Switch Inoperative

Odometer Trip/Reset Switch Inoperative

Diagnostic Fault Information

Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview

Circuit/System Description

The instrument panel cluster (IPC) calculates the mileage based on the vehicle speed signal circuit from the engine control module (ECM)/powertrain control module (PCM). The ECM/PCM sends the vehicle speed information via serial data to the IPC. The odometer will display 'error' if an internal IPC memory failure is detected. The odometer displays either miles or kilometers as requested by the activation of the Personalization button on the steering wheel controls.

Circuit/System Testing

Ignition ON, press the trip reset button a few times to verify the odometer and trip odometer.

If the odometer display does not switch between trip and odometer, replace the IPC.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

Control Module References for IPC replacement, setup, and programming