C0131

DTC C0131

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure, Diagnostic System Check - Vehicle
* Review Strategy Based Diagnosis for an overview of the diagnostic approach, Strategy Based Diagnosis
* Diagnostic Procedure Instructions provides an overview of each diagnostic category, Diagnostic Procedure Instructions



DTC Descriptor
DTC C0131 00
- ABS Pressure Circuit No Additional Information




Circuit/System Description

The electronic brake control module (EBCM) uses input from the brake pressure sensor for more accurate control during a Vehicle Stability Enhancement System (VSES) event.


Conditions for Running the DTC

* The ignition is ON.
* Ignition voltage is greater than 8 volts.



Conditions for Setting the DTC

* Brake signal does not correlate to pressure signal.
* Signal is erratic and changes faster than physically allowed.



Action Taken When the DTC Sets

* The Traction Control indicator turns ON.
* The driver information center (DIC) displays the Service Stability System message.



Conditions for Clearing the DTC

* The condition for setting the DTC is no longer present and the DTC is cleared with a scan tool.
* The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.



Reference Information

Schematic Reference

Antilock Brake System Schematics, [1][2]Antilock Brakes / Traction Control Systems

Description and Operation

ABS Description and Operation, Description and Operation

Electrical Information Reference

* Circuit Testing, Circuit Testing
* Connector Repairs, Connector Repairs
* Testing for Intermittent Conditions and Poor Connections, Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs, Wiring Repairs

Scan Tool Reference

Control Module References for EBCM, Control Module References


Circuit/System Testing

1. Apply and release brake pedal. Verify brake lamps operate properly.

• If brake lamps do not operate properly, refer to Symptoms - Lighting Systems, Symptom Related Diagnostic Procedures

2. Replace EBCM/brake pressure modulator valve (BPMV) assembly.



Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure, Verification Tests


Brake Pressure Modulator Valve Replacement for BPMV assembly replacement, setup, and programming, Service and Repair