C0359

DTC C0359

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.



DTC Descriptor
DTC C0359
- Four Wheel Drive Low Range (4WD low) Discrete Output Circuit Malfunction




Circuit/System Description

The 4WD LO circuit is used to notify the powertrain control module (PCM) that the vehicle is in 4WD low range. The PCM supplies 12 volts to this circuit. The transfer case shift control module grounds this circuit when the vehicle is in 4WD low range.


This DTC detects a short to ground, short to voltage or an open in the 4WD LO circuit.


Conditions for Running the DTC

* The ignition is ON.
* System voltage is 9-18 volts.



Conditions for Setting the DTC

* After the transfer case shift control module grounds the output, the 4WD LO circuit, and reads back a high voltage, the DTC sets. The system does not attempt setting the DTC again for 5 seconds.
* The transfer case shift control module reads back a high voltage when a low voltage is expected on the 4WD LO circuit.



Action Taken When the DTC Sets

* Transmission shift points may be affected.
* The SERVICE 4WD indicator remains illuminated for the remainder of the current ignition cycle.



Conditions for Clearing the DTC

* The transfer case shift control module clears the DTC if the condition for setting the DTC is not currently present.
* A history DTC clears after 100 consecutive ignition cycles without a fault present.
* History DTCs can be cleared using a scan tool.



Reference Information
Schematic Reference

Transfer Case Control Schematics (NVG 126-NP4 - Transfer Case)
Connector End View Reference

Component Connector End Views
Description and Operation

Transfer Case Description and Operation (NVG 226-NP8 - Transfer Case)
Electrical Information Reference

* Circuit Testing
* Connector Repairs
* Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs

Scan Tool Reference

* Scan Tool Output Controls (Scan Tool Output Controls)
* Scan Tool Data List (Scan Tool Data List)
* Scan Tool Data Definitions (Scan Tool Data Definitions)



Circuit/System Verification

TBD


Circuit/System Testing

TBD


Component Testing

TBD


Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.


Repair Verification

TBD