C0558

DTC C0558

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.



DTC Descriptor
DTC C0558
- Calibration Data Not Programmed/Learned




Circuit/System Description

The electronic brake control module (EBCM) must be calibrated.


Conditions for Running the DTC

* The ignition is ON.
* Ignition voltage is greater than 8 volts.



Conditions for Setting the DTC

The EBCM has not been calibrated.


Actions Taken When DTC Sets

* The EBCM disables the ABS and the TCS for the duration of the ignition cycle.
* The ABS indicator turns ON.



Conditions for Clearing the DTC

* The condition for the DTC is no longer present and the DTC is cleared with a scan tool.
* The electronic brake control module (EBCM) automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.



Reference Information
Schematic Reference

Antilock Brake System Schematics ([1][2]Antilock Brakes / Traction Control Systems)
Connector End View Reference

Component Connector End Views
Description and Operation

ABS Description and Operation (Description and Operation)
Electrical Information Reference

* Testing for Intermittent Conditions and Poor Connections
* Circuit Testing
* Connector Repairs
* Wiring Repairs

Scan Tool Reference

Control Module References for Scan Tool information.


Circuit/System Verification

Calibrate the EBCM. Refer to Control Module References .


Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.


Control Module References for EBCM calibration