B1011

DTC B1011

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview)provides an overview of each diagnostic category.

DTC Descriptor
DTC B1011
- System Disabled Information Stored

Circuit/System Description

The power sliding door module (PSDM) can detect when the clutch assembly cable is not connected. A disconnected or broken cable, cable bracket, cable fastener or a malfunctioning PSDM are the only events which can cause the DTC to be set. Except for the class 2 serial data communications circuits, no electrical circuits are involved in the setting of this DTC.

Conditions for Running the DTC

A power sliding door open or close function is attempted.

Conditions for Setting the DTC

The PSDM has detected that the PSD motor and clutch assembly cable is not connected.

Action Taken When the DTC Sets

* The PSDM will attempt to operate the PSD and stop if the condition is current.
* The PSDM sets a DTC B1011.

Conditions for Clearing the DTC

When the failure is no longer present or when the DTC has been cleared with a scan tool.

Reference Information
Schematic Reference

Sliding Door Schematics (Sliding Door Schematics)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Power Sliding Door (PSD) Description and Operation (Description and Operation)
Electrical Information Reference

* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Circuit Testing (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning)for Scan Tool Information

Circuit/System Verification

Ignition ON, command the appropriate power sliding door to open and close by pressing the appropriate open/close switch on the Overhead Console Multifunction Switch. The appropriate power sliding door should open and close as commanded.

If the appropriate power sliding door fails to open and close, inspect the cable on the appropriate power sliding door. If the cable assembly is broken, replace the cable assembly. If the cable is intact, replace the appropriate PSDM.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

* Rear Side Door Actuator Control Module Programming and Setup (Programming and Relearning)
* Rear Side Door Actuator Control Module Replacement (with E58) (Service and Repair)Rear Side Door Actuator Control Module Replacement (with E59) (Service and Repair)
* Power Sliding Door Motor Clutch Replacement (RPO E58) (Service and Repair)Power Sliding Door Motor Clutch Replacement (RPO E59) (Service and Repair)