Tightening Torques & Sequences

Left - Right:

Cylinder Head Bolt
First pass 60 Nm (44 lb ft)
Final pass 95 degrees

CYLINDER HEAD BOLT RE-USABILITY

Notice: This component uses torque-to-yield bolts. When servicing this component do not reuse the bolts, New torque-to-yield bolts must be installed. Reusing used torque-to-yield bolts will not provide proper bolt torque and clamp load. Failure to install NEW torque-to-yield bolts may lead to engine damage.

INTAKE MANIFOLD

Lower Intake Manifold Bolt - Center
First Pass 7 Nm (62 lb in)
Final Pass 13 Nm (115 lb in)

Lower Intake Manifold Bolt - Corner
First Pass 13 Nm (115 lb in)
Final Pass 25 Nm (18 lb ft)

Upper Intake Manifold Bolt/Stud 25 Nm (18 lb ft)

MAIN BEARING CAP

Crankshaft Main Bearing Cap Bolt/Stud
First Pass 50 Nm (37 lb ft)
Final Pass 77 degrees

ROD BEARING CAP

Connecting Rod Bearing Cap Bolt
First Pass 20 Nm (15 lb ft)
Final Pass 75 degrees

CRANKSHAFT PULLEY

Crankshaft Balancer Bolt
First pass 125 Nm (92 lb ft)
Final pass 130 degrees

FLYWHEEL/FLEXPLATE A/T

Flywheel Bolt 71 Nm (52 lb ft)

OIL PUMP

Oil Pump Mounting Bolt 41 Nm (30 lb ft)
Oil Pump Cover Bolt 10 Nm (89 lb in)

EXHAUST MANIFOLD

Exhaust Manifold Nut 16 Nm (12 lb ft)

WATER PUMP

Water Pump Bolt 11 Nm (98 lb in)