C0914

DTC C0914

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (with HP2) (Initial Inspection and Diagnostic Overview)Diagnostic System Check - Vehicle (without HP2) (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.

DTC Descriptor
DTC C0914 06
- Device Voltage Output 1 Circuit Short to Ground or Open

Conditions for Running the DTC

* Ignition ON.
* The ignition voltage is greater than 10 volts.

Conditions for Setting the DTC

The EBCM has detected a short to ground or open on the yaw and lateral accelerometer sensor ignition circuit.

Action Taken When the DTC Sets

* The EBCM disables the traction control and the vehicle stability enhancement system (VSES) for the duration of the ignition cycle.
* A DIC message and/or a warning indicator may be displayed.

Conditions for Clearing the DTC

* The condition for the DTC is no longer present.
* The EBCM clears the history DTC when a current DTC is not detected in 40 consecutive drive cycles.

Reference Information
Schematic Reference

Antilock Brake System Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

ABS Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the yaw and lateral accelerometer sensor.
2. Ignition OFF, test for less than 5.0 ohm between the low reference circuit terminal 6 and ground.

• If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the EBCM.

3. Ignition ON, test for B+ between the ignition circuit terminal 1 and ground.

• If less than the specified range, test the ignition circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the EBCM.

4. If the circuits test normal, replace the yaw and lateral accelerometer sensor.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

* Vehicle Yaw Sensor with Vehicle Lateral and Longitudinal Accelerometer Replacement (Service and Repair)
* Control Module References (Programming and Relearning) for EBCM replacement, setup, and programming