Instrument Panel Cluster Trim Plate Bezel Replacement

Instrument Panel Cluster Trim Plate Bezel Replacement (Chevrolet)

Removal Procedure

1. Tilt the steering wheel to the full down position.
2. Remove the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side (Service and Repair).
3. Remove the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement (Service and Repair).




4. Remove the screws retaining the bezel to the instrument panel.
5. Remove the bezel from the instrument panel.
6. If equipped, remove the transfer case shift control switch. Refer to Transfer Case Shift Control Switch Replacement (GMC, Buick) (Service and Repair).
7. Remove the rear wiper washer switch. Refer to Rear Window Wiper and Washer Switch Replacement (Service and Repair).
8. If equipped, remove the cigar lighter or 12-volt power supply outlets. Refer to 12-Volt Accessory Power Receptacle Replacement (12-Volt Accessory Power Receptacle Replacement).
9. Remove the bezel from the vehicle.

Installation Procedure




1. If equipped, install the cigar lighter or 12-volt power supply outlets. Refer to 12-Volt Accessory Power Receptacle Replacement (12-Volt Accessory Power Receptacle Replacement).
2. Install the rear wiper washer switch. Refer to Rear Window Wiper and Washer Switch Replacement (Service and Repair).
3. If equipped, install the transfer case shift control switch. Refer to Transfer Case Shift Control Switch Replacement (GMC, Buick) (Service and Repair).
4. Install the bezel to the instrument panel.

Caution: Refer to Fastener Caution (Fastener Caution).

5. Install the screws retaining the bezel to the instrument panel.

Tighten the screws to 2.5 Nm (22 lb in).

6. Install the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement (Service and Repair).
7. Install the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side (Service and Repair).