B1011

DTC B1011

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor
DTC B1011
- System Disabled Information Stored

Circuit/System Description

The power sliding door module (PSDM) can detect when the clutch assembly cable is not connected. A disconnected or broken cable, cable bracket, cable fastener or a malfunctioning PSDM are the only events which can cause the DTC to be set. Except for the serial data communications circuits, no electrical circuits are involved in the setting of this DTC.

Conditions for Running the DTC

A power sliding door open or close function is attempted.

Conditions for Setting the DTC

The PSDM has detected that the power sliding door motor and clutch assembly cable is not connected.

Action Taken When the DTC Sets

The PSDM will attempt to operate the power sliding door and stop if the condition is current.

Conditions for Clearing the DTC

* The DTC will be current for as long as the cable failure is present.
* When the failed cable assembly has been replaced, the DTC will be a history DTC.

Reference Information
Schematic Reference

Sliding Door Schematics Sliding Door Schematics
Connector End View Reference

Component Connector End Views
Description and Operation

Power Sliding Door (PSD) Description and Operation Description and Operation
Electrical Information Reference

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Circuit Testing Circuit Testing
* Wiring Repairs Wiring Repairs
* Connector Repairs Connector Repairs

Scan Tool Reference

Control Module References Control Module References for scan tool information

Circuit/System Verification

Ignition ON, command the appropriate power sliding door to OPEN and CLOSE by pressing the open/close switch on the overhead console multifunction switch. The power sliding door should OPEN and CLOSE as commanded.

If the power sliding door fails to OPEN and CLOSE, inspect the cable assembly on the power sliding door. If the cable assembly is broken, replace the cable assembly. If the cable assembly is normal, replace the PSDM.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

* Power Sliding Door Motor Clutch Replacement (RPO E59) Power Sliding Door Motor Clutch Replacement (RPO E59)Power Sliding Door Motor Clutch Replacement (RPO E58) Power Sliding Door Motor Clutch Replacement (RPO E58)
* Control Module References Control Module References for PSDM replacement, programming, and setup.