Automatic Transmission/Transaxle: Adjustments

Fig. 26 Adjusting shift linkage. JM600 models:

Gearshift Linkage

1. Place selector lever in Neutral position.
2. Loosen lever to control rod attaching bolts.
3. Position side lever in Neutral position, then tighten attaching bolts, Fig. 26.

Fig. 27 Adjusting inhibitor switch. JM600 models:

Inhibitor Switch

1. Place manual lever in Neutral position (vertical), then remove screw as shown, Fig. 27.
2. Loosen attaching bolts, then insert a .079 inch diameter pin into screw bore.
3. Move switch assembly until pin can be inserted into rotor, then torque attaching bolts to 3.6-5.1 ft-lbs.
4. Insert and tighten screw, Fig. 27.

Kickdown Switch

1. Loosen locknut, then extend switch until accelerator pedal lever makes contact with switch and clicks. Do not allow switch to make contact too soon or transmission will downshift on part throttle.