Wipers Do Not Return to Park Position

Fig. 1 Two-speed Motor Terminal Locations:

Fig. 2 Intermittent Wiper Motor Terminal Locations:

Fig. 3 Wiper Motor Terminal Location:

1. Remove wiper motor wire connector and clean terminals.
2. Place wiper switch in park position.
3. Connect a voltmeter between terminals P1 and L. If a reading of 12 volts is obtained at terminal P1, check voltage at terminal P2. If voltage at terminal P2 is zero, park switch is defective and gearbox assembly must be replaced. If there is 12 volts at terminal P2, there is an open circuit in wiper switch or wiring.