Cruise Control Servo: Service and Repair

REMOVAL
1. With throttle in full open position, remove the throttle cable and speed control cable from throttle lever.
2. Raise and support vehicle on hoist.

Fig.2 Speed Control System:

3. Remove two nuts attaching speed control cable and mounting bracket to servo.
4. Disconnect electrical connectors and vacuum hose.
5. Pull cable away from servo to expose retaining clip and remove clip attaching cable to servo.

INSTALLATION
1. Align hole in speed control cable sleeve with hole in servo pin and install retaining clip.
2. Connect vacuum hose to servo.
3. Connect electrical connector.
4. Insert servo studs through holes in speed control cable and mounting bracket.
5. Install nuts, tighten to 12 Nm (106.2 in. lbs.).
6. Lower vehicle.
7. Install speed control cable to throttle lever.
8. Install throttle cable to throttle lever.