Marker Lamp: Service and Repair

TAIL/STOP/SIDE MARKER/TURN SIGNAL LAMP UNIT

REMOVAL
1. Disconnect and isolate the battery negative cable.

Fig.23 Tail, Stop, Side Marker, Turn Signal Lamp Housing:

2. Under rear fender, remove nuts attaching the tail/stop/side marker/turn signal lamp assembly.
3. Remove the lamp assembly.
4. Disconnect wire connector from the lamp assembly.
5. Gently push lamp inward and remove.
6. Remove lamp assembly from vehicle.

INSTALLATION
1. Connect wire connector to the lamp assembly.
2. Position lamp assembly to rear fender.
3. Install the lamp assembly.
4. Install nuts attaching lamp and lamp assembly shield to rear fender.
5. Connect the battery negative cable.