Removal and Replacement

LIFTGATE

REMOVAL

NOTE: The liftgate does not have a outside mechanical release. For any service procedures that require disconnecting battery, open liftgate, if necessary before disconnecting battery.

1. Release liftgate latch and open liftgate.
2. Disconnect and isolate the battery negative cable.
3. Remove upper header trim panel. Refer to Trim Panel.
4. Disconnect liftgate wiring and hoses.
5. Support liftgate on a suitable lifting device.
6. Disconnect power liftgate link from liftgate.
7. Disconnect prop rods from liftgate.
8. Remove bolts attaching liftgate hinge to liftgate.
9. With assistance, remove liftgate from vehicle.

INSTALLATION

1. With assistance, place liftgate into position.
2. Support liftgate on a suitable lifting device.

NOTE: Use a suitable body sealer on the hinge to body mating surfaces prior to installation.

3. Install nuts attaching liftgate hinge to liftgate.
4. Connect prop rods to liftgate.
5. Connect power liftgate link to liftgate.
6. Connect liftgate wiring and hoses.
7. Install upper header trim panel.
8. Check liftgate for proper alignment. Refer to Body and Frame/Specifications/Dimensions.