P0585
P0585-SPEED CONTROL MULTIPLEXED SWITCH 1/2 CORRELATIONFor a complete wiring diagram, refer to: Electrical Diagrams
When Monitored
Continuously with the ignition on.
Set Condition
The Steering Column Control Module (SCCM) has detected that a non-permissible combination has occurred in the Speed Control Switch.
Possible Causes
- INTERMITTENT SPEED CONTROL MULTIPLEXED SWITCH 1/2 CORRELATION DTC
- SPEED CONTROL SWITCH
- STEERING COLUMN CONTROL MODULE (SCCM)
Diagnostic Test
1. DTC IS ACTIVE
NOTE: If P0562-BATTERY VOLTAGE LOW or P0563-BATTERY VOLTAGE HIGH is set along with this DTC, diagnose the battery voltage DTC first.
Ignition on, engine not running.
With the Scan Tool, select View DTCs in the Steering Column Control Module.
Is the DTC status Active at this time?
Yes >> Go to 2
No >> Go to 4
2. SPEED CONTROL SWITCH
Turn the ignition off.
Replace the Speed Control Switch in accordance with the Service Information.
Turn the ignition on. Move the Speed Control Switch to each position several times.
With the Scan Tool, Clear Stored DTCs in the Steering Column Control Module.
With the Scan Tool, select View DTCs in the Steering Column Control Module.
Move the Speed Control Switch to each position several times while monitoring the Scan Tool.
Does this DTC reset?
Yes >> Go To 3
No >> Test Complete.
3. STEERING COLUMN CONTROL MODULE (SCCM)
View repair.
Repair
Replace the Steering Column Control Module (SCCM) in accordance with the Service Information.
4. INTERMITTENT SPEED CONTROL MULTIPLEXED SWITCH 1/2 CORRELATION DTC
The conditions necessary to set this DTC are not present at this time.
While monitoring the scan tool data relative to this circuit, move the Speed Control Switch to each position several times.
Look for the DTC to reset while the switch is being moved to each position.
Were any problems found?
Yes >> Repair as necessary
No >> Test complete.